19. Oct 2026

The developmental two-component polyurethane is intended to provide a lower-cost alternative to silicone in the encapsulation of automotive electronic components.
Tosoh has developed a flexible polyurethane system designed to retain its performance across temperatures ranging from below −40 °C to at least 150 °C.
The Japanese chemicals producer is targeting encapsulation materials used to protect automotive electronic components such as electronic control units, sensors and cameras from heat, moisture and mechanical shock.
Tosoh said the material is the first polyurethane developed to cover this temperature range. Silicone currently dominates demanding electronic-encapsulation applications because it combines low-temperature flexibility with high-temperature resistance.
However, Tosoh said low-molecular-weight siloxanes present in silicone materials can cause electrical-contact problems, while other silicone-related substances can inhibit curing or impair adhesion to electronic substrates.
The new two-component PU system combines a specially developed liquid polycarbonate diol with a hexamethylene diisocyanate trimer. Tosoh adjusted the diol’s molecular structure to balance properties that are normally difficult to achieve simultaneously: low-temperature flexibility, heat resistance and sufficiently low viscosity for dispensing around electronic components.
In dynamic mechanical analysis, a standard formulation based on the new polycarbonate diol recorded a storage modulus of approximately 70 MPa at −40 °C. Adding plasticizer reduced this to 10 MPa, indicating greater flexibility. A formulation made with a conventional liquid polycarbonate diol exceeded 1,000 MPa at the same temperature.
The developmental formulations also underwent accelerated durability testing. Samples were exposed for 2,000 hours at 150 °C and separately at 85 °C and 85% relative humidity. Tosoh reported that the formulations retained broadly stable storage modulus, hardness, Young’s modulus and elongation values.
By comparison, a polyurethane based on a diene polyol experienced a tenfold increase in its −40 °C storage modulus after 2,000 hours at 150 °C, indicating a substantial loss of low-temperature flexibility.
Tosoh has also evaluated a temperature-sensitive catalyst intended to combine a long working time with rapid heat curing. The catalyst reduced curing time at 120 °C to 15 minutes while maintaining a working time of more than 60 minutes at 40 °C. A conventional metal catalyst required 60 minutes to cure at the lower dosage or reduced working time to ten minutes when used at a higher concentration.
The company is investigating whether the faster-curing formulation could be processed using infrared heating to reduce curing energy and associated carbon dioxide emissions.
Beyond electronic encapsulation, Tosoh is considering the material for automotive adhesives and thermally conductive gap fillers, including materials used around electric-vehicle battery packs. It has not disclosed a product name, commercialization timetable or planned production capacity.
Caption: An electronic component encapsulated with Tosoh’s developmental flexible polyurethane system. The material is designed to remain functional from below −40 °C to 150 °C. Photo: Tosoh